Delta Manual

Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized Avanti Products service center.

The water cooler is pre-cleaned at the factory but the reservoir and water lines must be flushed with fresh water before use as follows:

• Keep the unit unplugged.
• Fill water tank with tap water full to capacity (about 20 ounces). Wait for 5 minutes until water settles.
• Proceed to drain the water from both faucets until no more water remains.
• Then, drain any water left in the tanks by opening the water drain caps located on the bottom, until it drains completely.
• Proceed to close the drain caps. Also make sure both faucets are closed.
• Place the water bottle on the water intake, allow water to stand for approximately one minute.
• Open water faucets to insure water flows from both faucets.
• Plug dispenser into the electrical outlet.

Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized Avanti Products service center

Cold Water Control

Turn the switch marked “COLD” ON. The green (COLD) indicator will be lit and the process begins. When the water reaches the right temperature the green (COLD) indicator goes off automatically.

Download Avanti WD30EC Owner’s Manual

Related Posts

Avanti WD29EC Dispenser Plug the appliance into an exclusive properly installed-grounded wall outlet.... 

SERVICE FOR YOUR WATER DISPENSER We are proud of our customer service organization and the network of... 

Electrical Connection This appliance should be properly grounded for your safety. The power cord of... 

Avanti WDP75 Dispenser Your water dispenser has been cleaned and sanitized before leaving the factory,... 

Electrical Connection This appliance should be properly grounded for your safety. The power cord of...