Delta Manual

Steps To Replace Water Bottle

• Use a clean cloth to wipe off neck of bottle.
• Remove cap, if there is one on.
• Insert the water bottle on the water intake over reservoir opening so it settles properly on it.
• Wipe off any water, which may have splashed on dispenser top.

Cold Water Control

Turn the switch marked “COLD” ON. The green (COLD) indicator will be lit and the process begins. When the water reaches the right temperature the green (COLD) indicator goes off automatically.

Hot Water Control

Turn the switch marked “HOT” ON. The red (HOT) indicator will be lit on and the unit will begin to heat the water. When the water reaches the right temperature the red (HOT) light goes off automatically. When the temperature goes down to approx. 86º C (187º F), the red indicator will glow again and another.

Water is not cold enough.

Check to be sure the COLD switch on the back is ON. Too much water has been drawn within a short period of time. If more than two 8 oz. Cups have been drawn within a 25 minute span, you will need to wait up to one hour to reach optimal temperature.

Water is not hot enough.

Check to be sure the HOT switch on the back is ON. Too much water has been drawn within a short period of time. If more than two 8 oz. Cups have been drawn within a 25 minute span, you will need to wait up to one hour to reach optimal temperature.

Download Avanti WD31 Owner’s Manual

Read Online

Related Posts

Electrical Connection This appliance should be properly grounded for your safety. The power cord of... 

Avanti WD29EC Dispenser Plug the appliance into an exclusive properly installed-grounded wall outlet.... 

Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under any circumstances... 

SERVICE FOR YOUR WATER DISPENSER We are proud of our customer service organization and the network of... 

Electrical Connection This appliance should be properly grounded for your safety. The power cord of...