Delta Manual

SERVICE FOR YOUR WATER DISPENSER

We are proud of our customer service organization and the network of professional service technicians that provide service on your Avanti appliances. With the purchase of your Avanti appliance, you can be confident that if you ever need additional information or assistance, the Avanti Products Customer Service team will be here for you.

Cold Temp (Energy Saver / Normal Modes):

The cold water cycle is not affected by either program and continuously runs to maintain a cold water temperature between 7ºC/44ºF and 10ºC/50ºF. Once the “Cold Switch” at the rear of the unit is turned ON the (blue) “COLD” cycle indicator will be on until the temperature of the water in the reservoir drops to 7?/44ºF or less, the (blue) “COLD” cycle indicator will turn off and the cooling cycle will stop until the temperature reaches 10?/50ºF, at which time the (blue) “COLD” cycle indicator will turn on again and the cooling cycle will start again.

Energy Saving Program:

When the PROGRAM button is pushed down, it’s under Energy Saving Program; The (green) E-S indicator will be displayed. During operation the (red) “WARM” cycle indicator will be displayed until the temperature of the water in the reservoir reaches 60ºC/140ºF.

Once the temperature reaches 60ºC/140ºF (approximately 4 minutes) the (red) “WARM” indicator will turn off and will remain off until the temperature of the water in the reservoir drops to 50ºC/122ºF at which time the (red) “WARM” cycle indicator will turn on and the cycle will start again.

Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized Avanti Products service center

Download Avanti WD31EC Dispenser Owner’s Manual

Related Posts

Electrical Connection This appliance should be properly grounded for your safety. The power cord of... 

Avanti WDP75 Dispenser Your water dispenser has been cleaned and sanitized before leaving the factory,... 

Steps To Replace Water BottleUse a clean cloth to wipe off neck of bottle. Remove cap, if there is... 

Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under any circumstances... 

Electrical Connection This appliance should be properly grounded for your safety. The power cord of...