Delta Manual

Electrical Connection

This appliance should be properly grounded for your safety. The power cord of this appliance is equipped with a three-prong plug which mates with standard three prong wall outlets to minimize the possibility of electrical shock.

Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized Avanti Products service center.

Steps To Replace Water Bottle

• Use a clean cloth to wipe off neck of bottle.
• Remove cap, if there is one on.
• Insert the water bottle on the water intake over reservoir opening so it settles properly on it.
• Wipe off any water, which may have splashed on dispenser top.

Water cooler is not cold enough

Check to be sure the power switch on the back is ON. Too much water has been drawn within a short period of time. If more than two 8 oz. Cups have been drawn within a 25-minute span, you will need to wait up to one hour to reach optimal temperature.

Cold Water Control

Turn the power switch on. The yellow (cool) indicator will be lit and the process begins. When the water reaches the right temperature the yellow (cool) light goes off and the green (cold) light turns on.

Download Avanti WDR32 Owner’s Manual

Related Posts

Avanti WD29EC Dispenser Plug the appliance into an exclusive properly installed-grounded wall outlet.... 

Steps To Replace Water BottleUse a clean cloth to wipe off neck of bottle. Remove cap, if there is... 

Electrical Connection This appliance should be properly grounded for your safety. The power cord of... 

Avanti WDP75 Dispenser Your water dispenser has been cleaned and sanitized before leaving the factory,... 

Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under any circumstances...