Delta Manual

Power On

To turn the RX75 on, simply press the Power button on the RX75’s Display/ Controller. When you turn the RX75 on, it goes through a sequence of alerts. If you prefer, you may program your RX75 for a shorter power-on sequence. See the Programming section for detai

Power-on indication

After RX75’s start-up sequence is complete, the matrix display will show “Highway,” “AutoScan,” or “City” to show which sensitivity mode is selected. If you prefer, you can select alternate power-on displays. See the Programming section for detailHow Safety Warning Systems Works

Safety Warning Systems, or SWS, is a modified K-band radar signal used to transmit important driving related information.

From the factory, your RX75 is programmed with SWS turned ON. If SWS is not used in your area, you can simply turn SWS reception OFF by using the RX75’s Programming feature.

The SWS system has 64 possible messages (60 allocated). The SWS messages your RX75 can decode and display are listed on the facing page

Download Now

Related Posts

Volume Press and hold the Volume/Mute button located on the top case to adjust the V955’s alert volume... 

Front Radar ReceiverDetermine the best location for the Radar Receiver. The best location is typically... 

Mounting Location WARNING: BELTRONICS cannot anticipate the many ways the V995 can be mounted. It is... 

You can leave the Quick Mount bracket in place on your windshield, and easily remove the V965 by pressing... 

Beltronics Radar Vector 990 NORMAL (Factory Pre-Set Mode) A lengthy, power up test sequence that displays...