Delta Manual

Beltronics Radar Vector 990

NORMAL (Factory Pre-Set Mode)

A lengthy, power up test sequence that displays audio and text messages for Laser, Ka, K, X and Safety Warning System® (SWS™) followed by the status of the General Selectable Features each time the unit is turned on. When complete, unit is ready for operation and will display Radar, Laser and SWS™ messages when signals are detected. Normal Mode is recommended when first using your VECTOR 990.

TECH MODE (Displays Frequency Received)

Presents audio and text messages followed by the display of the ACTUAL frequency of the received radar bandwidth and Laser. Unit is ready for operation and will display Radar, Laser and SWS™ messages – including actual frequencies – when signals are detected

Reset to Factory Settings

You can reset your unit to factory settings (North American Mode) for Start-Up mode, volume, DRK, AUD, CTY and General Selectable Features. To reset, press and hold the CTY button with the unit on until the display shows “RESET“.Two“beeps” will sound and your unit will cycle through the NORMAL Start-Up Mode.

Engaging Travel Mode (for International Travel)

VECTOR 990 International is factory preset for North American Travel. For operation outside of North America, engage Tr a v e l Mode. To engage Tr a v e l Mode, with the unit ON, press and hold the CTY button until the display reads: Travel. Release the CTY Button

Download Beltronics Radar Vector 990 Manual

Related Posts

TECH MODE (VECTOR 960 only) Presents audio and text messages followed by the display of the ACTUAL frequency... 

Q-START (Quick-Start Mode) Unit will bypass the power up test sequence and will display the last selected... 

POWER CONNECTION To power V945, plug the elbow shaped jack into the receptacle on the side of the detector;... 

Volume Press and hold the Volume/Mute button located on the top case to adjust the V955’s alert volume... 

Set and Forget Memory Any time vector lr is turned off or unplugged from the cigarette lighter socket,...