Delta Manual

SQUAT PLATFORM & FRAME ASSEMBLY

Locate the following parts for this step:

• Large plastic squat platform (Item #5)
• Squat frame (Item #4)
• Four (4) 3/8″X4-3/4″ bolts (Item #52)
• Six (6) 3/8″ washers (Item #54)
• Two 3/8″ lock nuts (Item #57)

1. Align the holes in the main frame (Items #2&3) and the squat frame (Item #4) and insert the four bolts with washers on them into the four holes as shown in Figure C. Do not tighten at this time.
2. Slide the squat platform onto the frame assembly by aligning the notches on the sides with the bolts on the frame assembly. Make sure the platform goes behind the washers.
3. Place washers and nuts on the inside of the two forward bolts. Apply downward pressure to the platform by kneeling on it and tighten all the bolts.

Note: The two rear bolts do not require the use of a washer or lock nut on the inside of the assembly.

LAT TOWER ASSEMBLY 17

Locate the following parts for this step:

• Lat cross bar w/ pulleys (Item #17)
• Upper lat tower (Item #19)
• Two (2) 3/8″X2-3/4″ bolts (Item #50)
• Four (4) 3/8″ washers (Item #54)
• Two (2) 3/8″ nylon lock nuts (Item #57)

Download Now

Related Posts

With the Base Frame Assembly (from Step 1) on the floor, center the Lower Lat Tower Assembly over the... 

Select where you are going to locate your Bowflex Ultimate® 2 home gym carefully. The best place for... 

Basic Assembly Principles Here are a few basic tips that will make your assembly of the Bowflex Xtreme®... 

Basic Assembly Principles Here are a few basic tips that will make your assembly of the Bowflex Xtreme®... 

Always read and follow the Warning and Safety labels attached to your Bowflex® Blaze™ home gym. Do...