Delta Manual

Important

In order to avoid any leakage of the cleaning fluid, place the Clean&Renew™ station on a flat, stable surface.

Do not tip, move suddenly or transport the station in any way if a cleaning cartridge is installed. Do not place the station in a mirror cabinet, store it over radiators, or place it on polished or laquered surfaces. Do not expose to direct sunlight. The station contains highly flammable liquid. Keep it away from sources of ignition. No smoking. Keep out of reach of children.Before shaving

If you wish, you may start shaving right away (if the shaver is charged, see section «Shaver display»). However, we recommend to follow the procedure described here:

• Using the special cord set (1), connect the socket of the Clean&Renew™ station (7) to an electrical outlet.
• Press the station lift button (4) to open the housing.
• Hold the cleaning cartridge (8) down on a flat, stable surface (e.g. table).
• Carefully remove the lid from the cartridge.
• Slide the cartridge into the base of the station as far as it will go.
• Slowly close the housing by pushing it down until it locks.

We recommend cleaning after each shave.

While the cleaning is in progress, the respective cleaning program light will flash. Each cleaning consists of several cycles (where the cleaning fluid is flushed through the shaver head) and a heat drying period. The total cleaning time is 33 to 50 minutes.

Download Now

Related Posts

Before shaving If you wish, you may start shaving right away (if the shaver is charged, see section... 

Your Activator (shaver with Clean&Charge station) is a system equipped with highly advanced electronic... 

Warning Keep the appliance dry. Your shaver is provided with a special cord set with integrated Safety... 

Cleaning The hand-held unit should be detached from the power supply cord before cleaning. The shaver... 

Cleaning This appliance is suitable for cleaning under an open water tap. Warning: Detach the hand-held...