
Eton Viper 40/RXL40 Owner’s Manual
ride this vehicle unless it has been properly maintained and adjusted. Always perform a pre-ride inspection of your vehicle. Look for wires, bolts and other fasteners that may have come loose on previous...
Download manual handbook guide

ride this vehicle unless it has been properly maintained and adjusted. Always perform a pre-ride inspection of your vehicle. Look for wires, bolts and other fasteners that may have come loose on previous...

TURNING The ride must learn to move his weight and control the throttle to allow the tires to turn properly. When turning, the wheels on the outside of the turn must travel a wider radius and thus...

Safety Switch The safety switch is located behind the rear fender. To operate the vehicle, the switch cap must be connected to the safety switch. The switch cap is attached to a rope. This rope should...

TIRES Check the tire pressure frequently with an air pressure gauge. You should check the pressure before running the vehicle when the tires are cold. Tires should be inflated to the following recommended...

Throttle Lever The throttle lever is beside the right handlebar grip and is activated by the right hand thumb. To accelerate the vehicle, simply press the lever forward and open the throttle. To decelerate,...

Trouble shooting Fail to startGasoline mixed with water, Please replace it. The spark plug has accumulated carbon or has been broken through. Poor contact of the high – voltage wire with the spark...

TIRES AND WHEELS The X-Treme XG505 uses an identical rim and tires assembly on the front and rear wheels, which means that the tires can be rotated. The wheels are actually two wheel halves (split rim)...

Attach the gas tank. Using the two enclosed bolts and nuts, attach the gas tank to the right side of the rear frame. Run the gas lines around the frame to the engine by gently tucking them under the rear...

HANDLEBARS Insert Grips into Handlebar T-Frame as shown in fig 3. Be sure that Snap Pins fit into, and lock, the small holes in the top of the T-Frame. With the handlebars in the upright & locked...

Insert the seat post and seat into the seat post receiver, and then install the trunk rack to the rear of the scooter. Tighten the seat post clamp securely Charging Your scooter comes charged out of the...