Crest Century Series GTX Manual
Posted : Aug - 15 - 2010 @ : 6:06 am | Filled under: Mixers, Professional Audio
Crest Century Series GTX
Insert Send
This 1/4-inch jack is used for sending a post-input preamp, post Hi Pass Filter, pre-EQ signal to an outboard processor. The signal at this jack is unbalanced and always active regardless of the Insert Switch setting.
Bal Insert Return
This 1/4-inch balanced TRS jack receives it’s signal from an outboard processor. It can also be used to bring a signal into the channel, bypassing the input preamp and gain circuit. The return input is balanced and must be enabled by depressing the channel Insert switch.
Power Connections
The connections to and from the power supply vary depending on your specific configuration. Before setting up the console, always check to make sure the AC voltage marked on the power supply agrees with the local supply. Always connect the console to the power supply before switching on the power supply. Do not run the power supply if it is not connected to the console.
ADDITIONAL NOTE: The multi-conductor cable used for power supply-to-power supply connection is different than that used for a conventional power supply-to-console connection, and must be specified when the second power supply is ordered.
Segment LED Array
The signal is monitored pre-fader. Signal Present LED (green) responds to levels as low as -30 dB and comes to full brightness at -8dB, varying in intensity according to level. -6dB LED (green), 0dB LED (green), and +8 dB (yellow) illuminate accordingly. The Peak (red) LED responds to overloads at three points in the module; pre-EQ, post-EQ, and post-fade.
Three-Band Sweep Equalizer Controls
The equalization controls in this module act upon both L and R stereo channels at once. All three EQ bands are set up as sweep EQ’s: the upper knob controls the gain or cut (15 dB); while the lower knob controls the center frequency adjusted by the inner knob. Center frequencies are indicated around the lower knob.
Download Crest Century Series GTX Manual
Related Posts
Crest Century Series VX ManualCrest Century Series VX True Post Effect Sends This section will examine what happens to the effect (Aux)...
Crest Century Series TC ManualCrest Century Series TC Power Requirements The Century Series power supplies have certain electrical...
Crest Century Series LM ManualCrest Century Series LM Ground Linking Safety Considerations – Each new power supply is shipped...
Crest Century Series LMX ManualCrest Century Series LMX Power Requirements The Century Series power supplies have certain electrical...
Crest Century Series GT ManualCrest Century Series GT Comprehensive Talk back section allows access to all primary console outputs....
Tags: Crest, Crest Century GTX, Crest: Century GTX XEight, Crest GTX century board manual
No Responses to “Crest Century Series GTX Manual”