Delta Manual

Placing Large or Thick Documents

When you scan a large or thick document, you can remove the document cover. Just open it and pull it straight up. If you need to press the document flat while you copy or scan it, do not press too hard and be careful not to move it.

Cauntion: Do not use excessive force on the document cover, end do not twist it diagonally. You may damage the document cover

Inserting the Memory Card

1. Make sure the cx series is turned on
   • Note: When you print directly from a memory card, it is best if the CX6000 Series is not connected    to your computer (or your computer should be turned off). If you see a message on your    computer screen when you insert a card in the CX6000 Series, just cancel the operation and close the screen.
2. Open the memory card door.
3. Make sure the memory card access light is off and that no cards are in any of the slots. Then insert your card into the correct slot. The memory card access light flashes and then stay on.
4. Close the memory card door. Now you can:

• View your photos on the photo viewer screen and print them (see the next section)
• Print an index sheet so you can select which photos to print (see the next column)
• Print all the photos on the card (see page 10)
• Print photos pre-selected on your camera using DPOF (see page 10)
• Print the date your photos were taken on the photos (see page 11)

When you want to remove the card, make sure the memory card access light is not flashing, then pull the card straight out of its slot.

Download Now

Related Posts

Epson Perfection V750-M Scanning a Document or Photo Before scanning a document, remember to respect... 

Sending a Fax Before you fax, place your original photo or document on the document table glass. Then... 

Epson Perfection 3490 PHOTO Scanning Film and Slides The Perfection 3490 Photo scanner cover has a built-in... 

Epson Perfection 3200 PRO Scanning Transparencies and film Before scanning transparent documents, you... 

Epson Expression 1640XL SCSI interface Hardware: Initialized when the scanner is turned on or the scanner...