Delta Manual

Euro-Pro 7500XH

Lower Thread Tension

To test the bobbin thread tension, remove the bobbin case and bobbin from the machine and hold the bobbin case suspended by the thread. Shake it once or twice. If the suspended by the thread. Shake it once or twice. If the tension is correct, the thread will unwind by about an inch or two. If the tension is too tight, it will not unwind. If the tension is too loose, the thread will unwind for more than two inches.

Reverse sewing

Reverse sewing is used for locking the end of seams and where reinforcement is needed. At the end of seam, press down the reserve sewing lever and touch the foot control lightly. Sew a few reverse stitches. Release lever and the machine will sew forwards again.

Remove the zigzag foot and attach the buttonhole foot. Adjust the stitch length dial between “0.5″-”1″. The density of the stitch depends on thickness of the fabric.

Insert the cord between the spring covering the cord groove and the foot. The cord should run in the groove. One, two or three cords can be sewn on. The stitch width is adjusted according to the number of cords and the stitch selected.

Presser foot shown is the optional gathering foot which does not come with your machine. If you have not purchased this foot substitute the all purpose foot and gather fabric by hand by lowering the tension setting to below 2 and pulling the lower thread to gather the material.

Download Euro-Pro 7500XH Sewing Machine User’s Manual

Related Posts

Euro-Pro 8660 Lower Thread tension To test the bobbin thread tension, remove the bobbin case and bobbin... 

Euro-Pro Dressmaker 998B Make sure that the power switch is in the ‘OFF’ position. Insert the batteries... 

Euro-Pro 1100 Dressmaker II The Sewing Machine Stops Sewing Very heavy fabric or too many layers of fabric... 

Euro-Pro 9105 Polarized plug information This appliance has a polarized plug (one blade wider than the... 

Electronically controlled dual brewing cycle (left side only) slows down the brewing process when preparing...