Delta Manual

Euro-Pro 8660

Lower Thread tension

To test the bobbin thread tension, remove the bobbin case and bobbin from the machine and hold the bobbin case suspended by the thread. Shake it once or twice. If the tension is correct, the thread will unwind by about an inch or two. If the tension is too tight, it will not unwind. If the tension is too loose, the thread will unwind for more than two inches.

Reserve sewing is used for locking the and of seams and where reinforcement is needed. At the and of seam, press down the reverse sewing lever and touch the foot control lightly.

Function of stitch width dial

The maximum zigzag stitch width for zigzag stitching is “5″; however, the width can be reduced on any pattern. The width increases as you move zigzag dial from “0″-”5″.

Function of stitch length dial while zigzaging

The density of zigzag stitches increase as the setting of stitch length dial approaches “0″. Neat zigzag stitches are usually achieved at “2.5″ or below.

Position the work under the foot. Place the button on the marked position, lower the foot, adjust stitch width to “0″ and sew a few securing stitches. Adjust the stitch width. Turn the hand wheel to check that the needle goes cleanly into the left hole of the button (adjust the stitch width according to the button), and sew on the button. Adjust the stitch width to “0″ and sew a few securing stitches.

Download Euro-Pro 8660 Sewing Machine Manual

Related Posts

Euro-Pro 7500XH Lower Thread Tension To test the bobbin thread tension, remove the bobbin case and bobbin... 

Euro-Pro 1100 Dressmaker II The Sewing Machine Stops Sewing Very heavy fabric or too many layers of fabric... 

Euro-Pro Dressmaker 998B Make sure that the power switch is in the ‘OFF’ position. Insert the batteries... 

Euro-Pro 9105 Polarized plug information This appliance has a polarized plug (one blade wider than the... 

Electronically controlled dual brewing cycle (left side only) slows down the brewing process when preparing...