Delta Manual

BIOS Setup Program Modes

The BIOS Setup program has three modes of operation:

• Normal mode for normal operations
• Configure mode for clearing passwords (see Chapter 2 for instructions)
• Recovery mode for BIOS recovery

The BIOS Setup Program Operating mode is controlled by the setting of the configuration jumper block. The jumper is set to normal mode at the factory.

Maintenance Menu

This menu is used to clear passwords, to access the extended configuration sub menu, and to access processor information. Setup only displays this menu in the configure mode. See page 48 for information about setting the configure mode. To access this menu, select Maintenance on the menu bar at the top of the screenBIOS Beep Codes

The BIOS beep codes are listed in Table 33. The BIOS also issues a beep code (one long tone followed by two short tones) during POST if the video configuration fails (a faulty video card or no card installed) or if an external ROM module does not properly check sum to zero.

Preparing for the Update

Before you update the BIOS, prepare by:

• Obtaining the BIOS update file
• Saving the current BIOS settings
• Creating a boo table media
• Creating the BIOS upgrade media

Download Now

Related Posts

Intended Audience The TPS is intended to provide detailed, technical information about the board and... 

USB Support The desktop board has two back panels USB ports. You can connect two USB peripheral devices... 

Installation of Memory Modules (DIMM)2Core1333-2.66G motherboard provides two 240-pin DDRII (Double... 

Service and Troubleshooting GuideImportant safety information Warranty informationSafety and Warranty... 

About transferring media files You can connect your BlackBerry® device to your computer to transfer...