Delta Manual

Sparco Flat Seat Base

Attach the sliding tracks using the holes in the base closest to the center. The sliding tracks should be attached using a 6mm Allen wrench or Allen driver for the bolts and a standard wrench or socket for the 13mm locking nuts from kit 50001. The flat side of the sliding track should be facing the base with the release levers facing forward. Leave hardware loose until final fitment.

Tip: When installing the sliding track work on the front mounting holes first. Pull up on the release lever and slide the lower portion of the sliding track out to expose the mounting hole. Install the hardware as shown. Repeat the process for the rear mounting holes. Be sure when sliding the tracks back and forth that both tracks are at the exact same locking point/length or the sliders may bind later.

Additionally, make sure the front and rear of the sliding tracks are not cocked in the slotted mounting holes in the base. This will result in the sliding track not sliding smoothly. Leave hardware loose until final fitment.

The finished seat assembly is now ready for test fit. Make sure the seat has all the proper alignment and clearances preferred by the driver and make marks on the base assembly if necessary. Remove the seat assembly and tighten down all loose hardware.

Download Sparco Flat Seat Base Instructions

Related Posts

Sparco Tabbed Seat Base Next attach the seat adapter to the raised (top) side of the sliding tracks.... 

INSTALLATION Assemble the harness support rods as shown below using the provided hem joints and nuts.... 

INSTALLATION Assemble the harness support rods as shown below using the provided hem joints and nuts.... 

DISCLAIMER Motor sports are dangerous. No warranty or representation is made as to product’s ability... 

DISCLAIMER Motor sports are dangerous. No warranty or representation is made as to product’s ability...