Delta Manual

INSTALLATION

NOTE: You will need a #50 Torx bit for this installation

Assemble the harness support rods as shown below using the provided hem joints and nuts. Leave at least ¼” of thread showing on each hem joint to allow for adjustment during installation. Do not fully tighten the nuts at this time. NOTE: One end of each of the support rods has reversed thread.

On both sides of the vehicle’s interior, unsnap the plastic factory shoulder belt bolt cover and remove the Torx head bolt as shown here.Remove the factory retaining washer and remove the factory bolt from the factory harness. Assemble the hardware as shown and install the harness bar into the vehicle. Due to slight tolerance differences from vehicle to vehicle, you may need to bend the ends slightly for proper fit. Refer to step number 6 for proper factory harness routing. Do not tighten the bolts at this time.

On both sides of the vehicle’s interior, loosen and remove the lower seat belt Torx bolt from the vehicle

Download Now

Related Posts

INSTALLATION Assemble the harness support rods as shown below using the provided hem joints and nuts.... 

INSTALLATION Assemble the harness support rods as shown below using the provided hem joints and nuts.... 

DISCLAIMER Motor sports are dangerous. No warranty or representation is made as to product’s ability... 

DISCLAIMER Motor sports are dangerous. No warranty or representation is made as to product’s ability... 

Sparco Tabbed Seat Base Next attach the seat adapter to the raised (top) side of the sliding tracks....