Delta Manual

Sparco Tabbed Seat Base

Next attach the seat adapter to the raised (top) side of the sliding tracks. First remove the nuts from the captured bolts located on each end of the seat adapters. Then insert the captured bolt into the bolt holes at the end of each sliding track and fasten it with the nut that was removed. Tighten hardware all the way.

Tip: When installing the sliding track work on the front mounting holes first. Pull up on the release lever and slide the lower portion of the sliding track out to expose the mounting hole. Install the hardware as shown. Mount the tab brackets on the front and rear of the sliding tracks using this method.

Repeat the process but expose the mounting holes on the top half of the sliding tracks to mount the seat adapters. Be sure when sliding the tracks back and forth that both tracks are at the exact same locking point/length or the sliders may bind later. This will result in the sliding track not sliding smoothly.

Line up tab brackets with the tubular section of the base in the desired position. Fasten the tab brackets to the base using the four hex head bolts found in the 500 kit. Leave hardware loose until final fitment. The base assembly is now complete.

Tip: If the preferred setting of the height adjustment is the low setting and the tab bracket interferes with the floor or base it may be required to trim/cut the excess

Download Sparco Tabbed Seat Base Instructions

Related Posts

Sparco Flat Seat Base Attach the sliding tracks using the holes in the base closest to the center. The... 

INSTALLATION Assemble the harness support rods as shown below using the provided hem joints and nuts.... 

INSTALLATION Assemble the harness support rods as shown below using the provided hem joints and nuts.... 

DISCLAIMER Motor sports are dangerous. No warranty or representation is made as to product’s ability... 

DISCLAIMER Motor sports are dangerous. No warranty or representation is made as to product’s ability...