Delta Manual

Disclaimer

Since we are always staving to make our products better by incorporating new and improved materials, components, and manufacturing methods, we reserve the right to change these specifications at any time without notice.

“TAPCO” is a registered trademark of LOUD Technologies Inc. All other brand names mentioned are trademarks or registered trademarks of their respective holders, and are hereby acknowledged.

FLAT/FILTER-Pus this switch in to engage a high-cut filter to reduce hiss and noise when using the AMP input setting. The filter has no effect when the input is set to INST (2).

INST/AMP-Leave this switch out when connecting an instrument or line-level signal to the INPUT jack. Push this Switch in when connecting a speaker-level signal.

INPUT-Connect the signal source to this 1/4′ unbalanced TS jack.

POWER LED-Indicates when the power is on. When powered from the internal batteries, it lights when a signal is plugged into the INPUT jack. When powered from a mixer’s phantom power, it lights as long as the phantom power is applied.

PKUP/LINE-Move this switch to the left when connecting an instrument with a passive pickup, like an electric guitar. Move this switch to the right when connecting a line-level signal to the input.

Download TAPCO DIBOX DB-1A Owner’s Manual

Related Posts

OUTPUT-This balanced XLR jack provides a low-impedance mic-level signal for connecting to a microphone... 

The Link.USB Interface The Link.USB interface provides two analog audio inputs that can accept microphone... 

Getting Started Use this section to get your Link.Fire Wire set up quickly. Also refer to the Link.Fire... 

Connecting the Link.MIDI 4×4To stand the Link.MIDI 4×4 upright, pull the stabilizer bar... 

The BBE DI-10 is an active direct box used for converting line out and speaker out signals to balanced...