Uniden PRO510XL CB Radio Manual



Uniden PRO510XL

Uniden PRO510XL

The Citizens Band (CB) Radio Service is under the jurisdiction of the FCC. Any adjustments or alterations which would alter the performance of the transceiver’s original FCC type acceptance or would change the frequency determining method, are strictly prohibited.

Channel Selector – This switch selects the desired channel for transmission and reception. All channels, except channel 9, may be used for communications between stations operating under different license. Channel 9 has been reserved by the FCC for emergency communications involving the immediate safety of individuals or the immediate protection of property. Channel 9 also may be used to render assistance to a motorist. This is a FCC rule and applies to all operators of CB radios.

Antenna Connector – This female connector permits connection of the transmission line cable male connector (PL-259) to the transceiver.

Only a properly matched antenna system will allow maximum power transfer from the 50-ohm transmission line to the radiating element.We recommend that you use an SWR meter when installing your antenna. Set your PRO 510XL to channel 20 and make your adjustments to the antenna until the meter reads as close to 1 as possible.Your Uniden dealer is qualified to assist you in the selection of the proper antenna to meet your application requirements.

Connecting the Power Cord

With regard to the connection of the power cords, it may be possible or desirable to connect the red lead (for negative ground systems) or the black lead (for positive ground systems) to the ignition switch accessory terminal so that the radio is automatically turned off when the ignition switch (key) is turned off.

Alternately, the power lead may be connected to an available terminal on the fuse block or even to a point in the wiring harness. Care must be taken, however, to guard against a short circuit condition. When in doubt, please contact your vehicle dealer fro specific information about your vehicle.

Download Uniden PRO510XL CB Radio Manual


Related Posts

Uniden PC68ELITE CB Radio Manual

Uniden PC68ELITE Emergency OperationSet the switch to CH9 or turn Channel Selector knob to Channel... 

Uniden PRO510AXL CB Radio Manual

Uniden PRO510AXL Microphone Jack – The operational mode of the CB is controlled by the push-to-talk... 

Uniden PC78XL CB Radio Manual

Uniden PC78XL The FCC has ruled that CB Radio Service operators are no longer required to obtain an FCC... 

Uniden PC68XL CB Radio Manual

Uniden PC68XL CONNECTING THE POWER CORDS We recommend connecting the power lead to the Ignition Switch... 

Uniden PC78ELITE CB Radio Manual

Uniden PC78ELITE MOBILE STATION ANTENNA Because the maximum power output of the transmitter is limited... 

Tags: , uniden pro 510xl manual, uniden pro 510xl, Uniden Pro510xl, uniden pro510xl cb radio, Uniden PRO510XL Schematic, cb radio service manuals, Uniden Pro510XL CB

No Responses to “Uniden PRO510XL CB Radio Manual”

Leave a Reply