Delta Manual

Attach the gas tank.

Using the two enclosed bolts and nuts, attach the gas tank to the right side of the rear frame. Run the gas lines around the frame to the engine by gently tucking them under the rear fender.

Attach the seat post and seat.

Your scooter comes with 2 seat posts. One is inserted into the bottom of the seat and and secured by tightening the nuts. The second seat post is inserted into the opening on the rear/motor frame. Tighten the post in place by using the enclosed Allen wrench

Slide the seat post clamp over the bottom post and insert the upper seat post and attached seat in the bottom post and secure in place by tightening the clamp. You can adjust the height easily by loosening the clamp and pulling up or down on the seat, then tighten the clamp.Attach frame to motor/rear frame.

Having a second person hold the motor/rear frame slightly off the ground, insert the enclosed bolt thrum the holes on the side of the rear frame and into the tube on the front frame. Securely tighten the nuts on each end.

Attach the rear mono shock to the front frame

Using the enclosed bolt and nut, insert the shock into the bracket on the footplate. Secure in place by tightening the nut.

Download X-Treme Scooters X-Treme XG-499 Owner’s Manual

Related Posts

Insert the seat post and seat into the seat post receiver, and then install the trunk rack to the rear... 

HANDLEBARS Insert Grips into Handlebar T-Frame as shown in fig 3. Be sure that Snap Pins fit into, and... 

Trouble shooting Fail to startGasoline mixed with water, Please replace it. The spark plug has accumulated... 

TIRES AND WHEELS The X-Treme XG505 uses an identical rim and tires assembly on the front and rear wheels,... 

With the Base Frame Assembly (from Step 1) on the floor, center the Lower Lat Tower Assembly over the...